Article «Generator — removal and installation, disassembly and assembly» from the section «Gasoline engines → Engine electrical equipment» repair manuals for japanese cars «Mitsubishi Colt 5, petrol» 1995-2003 years of production.
3. Remove the generator drive belt. Generator drive belt installation. 1. Install a generator drive belt. 2. Install the A/C drive belt.. MZR 2.5. Removal. 1. Remove the aerodynamic under cover No.2 and splash shield as a single unit.. 2.
2. Insert a wrench onto the cast hexagon on the drive belt auto tensioner and release the tension by slowly turning in the direction shown in the figure. 3. Remove the generator drive belt. 4. Install the generator drive belt. 5. Rotate
Depends on the engine. first undo both bolts through the power steering tensioner pulley, (the adjuster quadrant and the pivot) then the pulley will push over to slacken the belt, and it comes off. Then at the alternator, undo the allen headed lower pinch bolt (proper fitting tool) and the hex headed upper adjuster bolts.
Control Panel REMOTE CONTROL AND MONITORING • Push and Release STOP (Prime) to stop the genset. Remote Series Digital Displays and • Push and Hold STOP (Prime) to prime the fuel Control Switches system (amber lamp comes on in 2 seconds to indicate priming).
TROUBLESHOOTING GENSET FAULTS in conjunction with the e-Series Digital Dis- If a fault shutdown occurs, the amber status lamp on play or blinking control switch status lamp to trouble- the control switch will repeatedly blink sets of 3, 4, 5 shoot the genset. Page 71 TABLE 9-1.
Page 16 Fault Screen If a fault shutdown occurs the ALARM status lamp will blink and the LCD screen will display the Fault Number, a description of the Fault and the hour in total genset running time when the Fault occurred (Figure 2-4). Refer to TABLE 9-1. TROUBLE- SHOOTING GENSET FAULTS to diagnose and correct the problem.
